Stone flour processing equipment may encounter various equipment problems during operation and processing. How to deal with them? Today, I'll analyze the problems often encountered by stone flour processing equipment and their solutions.

1.石磨面粉机机身晃动，应该拧紧磨头和机架之间的联接螺栓。

1. When the body of the stone flour mill shakes, the connecting bolts between the grinding head and the frame should be tightened.

2.产量下降，应调紧弹簧，以保证磨辊两端的间隙一致，对产生磨损的磨齿进行及时的修理。

2. When the output decreases, the spring shall be tightened to ensure that the clearance at both ends of the grinding roller is consistent, and the worn grinding teeth shall be repaired in time.

3.面粉温度高，应调松磨辊;若磨辊磨损比较严重时就应进行修理或更换；机温过高时就需进行停机散热。

3. If the flour temperature is high, loosen the grinding roller; If the grinding roller is seriously worn, it shall be repaired or replaced; When the machine temperature is too high, it needs to be shut down for heat dissipation.

4.不出麸皮，原因可能是主轴的转向不对，筛框的密封不严密或筛网出现破损。

4. No bran is produced, which may be due to the wrong rotation of the main shaft, the loose sealing of the screen frame or the damage of the screen.

5.不出粉或出粉少，原因为筛堵塞。

5. No or little powder is produced because the screen is blocked.

6.机械电压过低，配电线缺线，线路接触不良，控制回路断线，保险丝熔断等，导致无法启动。

6. The mechanical voltage is too low, the distribution line is missing, the line contact is poor, the control circuit is broken, the fuse is blown, etc., resulting in failure to start.

石磨面粉机在使用时要时常给机器各零件加润滑油，减少他们的磨损。

When the stone flour mill is in use, it is necessary to often add lubricating oil to all parts of the machine to reduce their wear and tear.